Monitoring Bridge Groups - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide

Monitoring Bridge Groups

show bridge
490
Use to remove all dynamic MAC address entries for a network interface belonging to
a bridge group from the forwarding table for that bridge group.
You must specify the following:
interfaceType—One of the following bridge interface types listed in Interface Types
and Specifiers in JunosE Command Reference Guide:
atm
fastEthernet
gigabitEthernet
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers in JunosE Command Reference Guide for
information
Example
host1#show bridge westford02 table dynamic
Bridge: westford02 MAC Address Table
Address
--------------
0090.1a01.0205
0090.1a01.0206
0090.1a01.0207
host1#clear bridge interface atm 3/3.2
host1#show bridge westford02 table dynamic
Bridge: westford02 MAC Address Table
Address
--------------
0090.1a01.0205
0090.1a01.0207
There is no no version.
See clear bridge interface.
You can use show commands to display information about the bridge groups configured
on your router.
Use to display configuration and statistics information for the specified bridge group.
To display information about the MAC address table and bridge interfaces, use the all
keyword.
Field descriptions
Action Interface
---------- -------------------
forward ATM3/3.1
forward ATM3/3.2
forward ATM3/3.3
Action Interface
---------- -------------------
forward ATM3/3.1
forward ATM3/3.3
Age
-----
0
10
5
Age
-----
0
5
Copyright © 2010, Juniper Networks, Inc.