References; Supported Features; Module Capabilities - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

References

Supported Features

Module Capabilities

Copyright © 2010, Juniper Networks, Inc.
example, the following command specifies ATM 1483 subinterface 20 on slot 5, adapter
0, port 0 of an E120 or E320 router.
host1(config)#interface atm 5/0/0.20
For more information about supported interface types and specifiers on E Series routers,
see Interface Types and Specifiers in JunosE Command Reference Guide.
For more information about ATM interfaces, consult the following resources:
ATM Forum—ATM User-Network Interface Specification, Version 3.0 (September
1993)
ATM Forum—ATM User-Network Interface Specification, Version 3.1 (September 1994)
ATM Forum—Integrated Local Management Interface (ILMI) Specifications, Versions
3.0, 3.1, and 4.0 (September 1996)
ATM Forum—Traffic Management Specification, Version 4.0 (April 1996)
ITU-T Draft Recommendation I.363 (AAL5 support) (January 1993)
RFC 2390—Inverse Address Resolution Protocol (September 1998)
RFC 2684—Multiprotocol Encapsulation over ATM Adaptation Layer 5 (September
1999) (RFC 2684 obsoletes RFC 1483)
ITU-T Recommendation I.610—B-ISDN Operation and Maintenance Principles and
Functions (February 1999)
Encapsulation Methods for Transport of ATM Over MPLS
Networks—draft-ietf-pwe3-atm-encap-07.txt (April 2005 expiration)
JunosE Release Notes, Appendix A, System Maximums—See the Release Notes
corresponding to your software release for information about maximum values
NOTE: IETF drafts are valid for only 6 months from the date of issuance.
They must be considered as works in progress. Please refer to the IETF
Web site at http://www.ietf.org for the latest drafts.
This section describes ATM feature support on E Series modules.
For more information about the physical layer characteristics of the modules described
in this section, including the numbering schemes, see the JunosE Physical Layer
Configuration Guide.
The level of support for certain ATM capabilities varies depending on the module. Table
5 on page 12 lists the specific differences in the capabilities of the modules.
Chapter 1: Configuring ATM
11