Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 175

Copyright © 2010, Juniper Networks, Inc.
Configured LMI type—One of the following options:
ANSI—ANSI T1.617 Annex D
Q933A—ITU-T Q.933 Annex A
Cisco—Original Group of Four specification developed by DEC, Northern Telecom,
Stratacom, and Cisco
None—Suppresses LMI
status is up—Availability of the MLFR bundle: up or down
Number of interface down transitions—Number of times the interface has become
unavailable
Time since last status change—elapsed time since LMI information changed
Enquiries sent—Total number of LMI status inquiries sent by the DTE on this
interface
Full enquiries sent—Total number of LMI full status inquiries sent by the DTE on
this interface
Enquiry responses received—Total number of LMI full and regular status responses
received by the DTE on this interface
Full enquiry responses received—Total number of LMI full status responses received
by the DTE on this interface
Async updates received—Total number of asynchronous LMI updates received by
the DTE on this interface
Unknown messages received—Total number of unknown LMI messages received
on this interface
Loss of sequencing detected—Total number of times a loss of sequencing in
received LMI messages was detected by the DTE on this interface
No response timeouts—Total number of times a timeout occurred without receiving
a response to an LMI request by the DTE on this interface
Last sequence number sent—Last sequence number sent on this interface
Last sequence number received—Last sequence number received on this interface
DCE field descriptions:
Frame relay DCE interface mlframe-relay—Name of the MLFR bundle
N391—Value of the N391 full-status polling counter
N392—Value of the N392 error threshold counter
T392—Value of the T392 polling verification timer
Chapter 3: Configuring Multilink Frame Relay
143