Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 173

Copyright © 2010, Juniper Networks, Inc.
Use to display the state of MLFR Link Integrity Protocol (LIP) on an MLFR link.
Use the brief keyword to display the operational status of all configured interfaces.
Use the delta keyword to specify that baselined statistics are to be shown.
Field descriptions
Frame relay interface—Specifier for the Frame Relay interface
Status of the major Frame Relay interface—One of the following states:
Up—Traffic can flow on the interface
Offline—Traffic cannot flow because hardware is unavailable
Down—Traffic cannot flow because of a problem in the interface at the current
protocol layer
LowerLayerDown—Traffic cannot flow because of a problem in an interface at a
lower protocol layer
AdministrativelyDown—Traffic cannot flow because of manual administrative
intervention
Number of interface down transitions—Number of interfaces that have changed to
a down state
Time since last status change—Time since the interface last changed its state
Add Links sent—Number of Add Link messages sent from this interface
Add Links received—Number of Add Link messages received on this interface
Add Link Acknowledgments sent—Number of Add Link acknowledgments sent from
this interface
Add Link Acknowledgments received—Number of Add Link acknowledgments
received on this interface
Add Link Rejects sent—Number of Add Link Reject messages sent from this interface
Add Link Rejects received—Number of Add Link Reject messages received on this
interface
Hellos sent—Number of Hello messages sent from this interface
Hellos received—Number of Hello messages received on this interface
Hello Acknowledgments sent—Number of Hello messages sent from this interface
Hello Acknowledgments received—Number of Hello messages received on this
interface
Remove Links sent—Number of Remove Link messages sent from this interface
Remove Links received—Number of Remove Link messages received on this interface
Chapter 3: Configuring Multilink Frame Relay
141