Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 618

JunosE 11.3.x Link Layer Configuration Guide
pppoe sessions
pppoe url
586
Use to specify the maximum number of PPPoE subinterfaces permitted on an interface,
in the range 1–8000 (ERX routers) or 1–32,000 (E120 and E320 routers). On the ES2
10G ADV LM (E120 and E320 routers), you can have PPPoE subinterfaces in the range
1–32,000. The default value is 8000 (ERX routers) or 16,000 (E120 and E320
Broadband Services Routers) or 32,000 (ES2 10G ADV LM).
The sessions command affects only the creation of subinterfaces after the command
is entered. Previously created interfaces remain, even if their number exceeds the new
value of the sessions parameter.
NOTE: The number of subinterfaces permitted on the interface for E120
and E320 routers is in the range 1–32,000 irrespective of the type of line
module. However, if you specify a value greater than the number of
subinterfaces supported by a line module, the number of subinterfaces
created is the default maximum value for that line module. For example,
if you specify the number of subinterfaces for a ES2 4G LM as 32,000
interfaces, the number of subinterfaces created is 16,000, which is the
default maximum value for the ES2 4G LM.
Example
host1(config-profile)#pppoe sessions 3000
Use the no version to restore the default value, 8000 (ERX routers) or 16,000 (E120
and E320 routers) or 32,000 (ES2 10G ADV LM).
See pppoe sessions.
Use in a profile to cause the PPPoE application to send the string to the new client
created when the profile is dynamically attached to an IP interface.
The message string is saved in nonvolatile storage (NVS).
PPPoE substitutes certain characters for information in the specified URL string before
transmitting:
%U username and domain name
%u username
%d domain name
%D profile name
%% % character
Example
host1(config-profile)#pppoe url http://www.relevanturl.com
Copyright © 2010, Juniper Networks, Inc.