Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 677

profile atm1483 bulk-config-name pvc
shutdown
Copyright © 2010, Juniper Networks, Inc.
Use to assign the base profile configured for a dynamic ATM 1483 subinterface to the
VC range configured on a static ATM AAL5 interface.
You must include both of the following:
Name assigned to the VC range on an ATM AAL5 interface, as specified in the atm
bulk-config command
Name assigned to the base profile for a dynamic ATM 1483 subinterface
Example
host1(config-if)#profile atm1483 bulk-config-name test1 test1BaseProfile
Use the no version to remove the base profile assignment.
See profile atm1483 bulk-config-name.
Use to assign an overriding profile to a single ATM PVC that exists within a
bulk-configured VC subrange.
An overriding profile typically includes debugging attributes that help you troubleshoot
problems with the ATM 1483 dynamic subinterface column created on the specified
PVC.
The VPI and VCI values of the PVC you specify must exist between the starting VPI/VCI
values and ending VPI/VCI values of a VC subrange previously configured with the atm
bulk-config command.
Example 1—In this example, a previously configured VC range named test1 includes a
VC subrange with VPIs 3–5 and VCIs 201–3200. The following command assigns an
overriding profile (test1DebugProfile) to the ATM PVC with VPI 4 and VCI 301 that is
within this subrange.
host1(config-if)#profile atm1483 bulk-config-name test1 pvc 4 301 test1DebugProfile
Example 2—Removes the overriding profile assignment from the ATM PVC with VPI 4
and VCI 301, and restores the original base profile assignment
host1(config-if)#no profile atm1483 bulk-config-name test1 pvc 4 301
Use the no version to remove the overriding profile assignment for the PVC and restore
the original base profile assignment.
See profile atm1483 bulk-config-name pvc.
Use to disable an interface.
When you disable a dynamic ATM 1483 interface, the shutdown command deletes
the ATM 1483 dynamic subinterface column and removes the dynamic ATM 1483
subinterface.
Example
host1(config-subif)#shutdown
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
645