Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 561

interface atm
profile
Copyright © 2010, Juniper Networks, Inc.
Use the no version to terminate detection of the specified encapsulation type or, if the
lockout-time keyword is specified, to restore the lockout time range to its default value,
1–300 seconds.
See auto-configure.
Use to select an ATM interface or ATM 1483 subinterface.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310 router,
use the slot/port.[subinterface ] format.
slot—Number of the chassis slot
port—Port number on the I/O module
subinterface—Number of the subinterface in the range 1–2147483647
To specify an ATM interface for E120 and E320 routers, use the
slot/adapter/port[.subinterface ] format.
slot—Number of the chassis slot
adapter—Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
port—Port number on the IOA
subinterface—Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 21 in "Configuring
ATM" on page 3.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 5/0/0.1
Use the no version to remove the interface or subinterface.
See interface atm.
Use to assign a profile.
You must specify the encapsulation type to which the profile applies: bridgedEthernet,
ip, ppp, pppoe ,or any.
Specify a profile name with up to 80 alphanumeric characters.
Example
host1(config-subif)#profile ppp foo
Chapter 17: Configuring Dynamic Interfaces
529