Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 90

JunosE 11.3.x Link Layer Configuration Guide
cbr
encapsulation
inarp
58
commands listed in Table 8 on page 57. For information about the default value for each
command, see the command descriptions in this section.
! Configure VC class with default values.
host1(config)#vc-class atm default-subscriber-class
host1(config-vc-class)#exit
host1(config)#
To verify the VC class configuration, use the show atm vc-class command. For information
about how to use this command, see "show atm vc-class" on page 97.
Use to configure the CBR service category on an ATM data PVC.
For detailed information about how to use this command, see "cbr" on page 47.
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
Example
host1(config-vc-class)#cbr 15000
host1(config-vc-class)#exit
Use the no version to restore the default service category, UBR without a PCR.
See cbr.
Use to configure the encapsulation method on an ATM data PVC.
For detailed information about how to use this command, see "encapsulation" on
page 48.
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
Example
host1(config-vc-class)#encapsulation aal5mux ip
host1(config-vc-class)#exit
Use the no version to restore the default encapsulation method, aal5snap.
See encapsulation.
Use to enable Inverse ARP on an ATM PVC that resides on an ATM 1483 NBMA
subinterface and uses the default encapsulation method, aal5snap.
For detailed information about how to use this command, see "inarp" on page 52.
You must issue the exit command from ATM VC Class Configuration mode for the
configuration to take effect.
Example
host1(config-vc-class)#inarp 5
Copyright © 2010, Juniper Networks, Inc.