Figure 42: Example Of Pppoe Stacking - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

encapsulation ppp
interface fastEthernet
Copyright © 2010, Juniper Networks, Inc.
(Optional) Configure an access concentrator (AC) name on the PPPoE interface.
5.
host1(config-subif)#pppoe acname CYM9876
(Optional) Set up the router to prevent a client from establishing more than one
6.
session using the same MAC address.
When the duplicate protection feature is enabled, multiple IWF PPPoE sessions (sent
from PPPoE clients to the PPPoE access concentrator) that contain the same MAC
address are still processed and can access network services until the maximum number
of PPPoE sessions configured per major interface (configured using the pppoe sessions
command) is reached.
host1(config-subif)#pppoe duplicate-protection
Assign an IP address and mask.
7.
host1(config-if)#ip address 192.6.129.5 255.255.255.0
(Optional) Configure additional PPPoE subinterfaces by completing Steps 3 through
8.
7 using unique numbering.
Figure 42 on page 399 illustrates the interface stack for this configuration.

Figure 42: Example of PPPoE Stacking

Use to specify PPP as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation ppp
Use the no version to disable PPP on an interface.
See encapsulation ppp.
Use to select a Fast Ethernet interface.
For more information, see chapter Configuring Ethernet Interfaces in JunosE Physical
Layer Configuration Guide.
Example
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
399