Configuring Dynamic Pppoe Over Static Pppoe With Ethernet And S-Vlan Interface Columns; Figure 53: Dynamic Pppoe Over Static Pppoe With S-Vlan Interface - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Configuring Dynamic PPPoE over Static PPPoE with Ethernet and S-VLAN Interface Columns

Copyright © 2010, Juniper Networks, Inc.
Use from Global Configuration mode to create a profile. You can specify a profile name
of up to 80 characters.
Use from Interface Configuration mode or Subinterface Configuration mode to assign
a profile to a PPP interface. The profile configuration is used to dynamically create an
upper IP interface.
Example 1–Creates a profile named foo.
host1(config)#profile foo
Example 2–Assigns a profile named action to a PPP interface.
host1(config-if)#interface gigabitEthernet 2/1
host1(config-if)#encapsulation ppp
host1(config-if)#profile action
Use the no version from Global Configuration mode to remove a profile.
Use the no version from Interface Configuration mode or Subinterface Configuration
mode to remove a profile assignment from an interface.
See profile
Figure 53 on page 539 shows dynamic PPPoE subinterface columns over PPPoE major
interfaces using S-VLANs over Ethernet.

Figure 53: Dynamic PPPoE over Static PPPoE with S-VLAN Interface

Columns
To configure an S-VLAN subinterface to support a dynamic PPPoE subinterface:
Specify a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet interface.
1.
host1(config)#interface fastEthernet 4/1
Chapter 17: Configuring Dynamic Interfaces
539