Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 666

JunosE 11.3.x Link Layer Configuration Guide
634
c. Configure the ATM 1483 subinterface for autodetection of the IP upper-interface
encapsulation type using a nondefault lockout time range of 3600–7200 seconds
(1–2 hours).
d. Configure a subscriber for the IP upper-interface encapsulation type.
e. Configure a description for ATM 1483 subinterfaces that are created with this base
profile.
f. Set an advisory speed for ATM subinterfaces that are created with this base profile.
g. Assign a VC class to the bulk-configured VC ranges created on the dynamic
ATM 1483 subinterfaces associated with this base profile. You must issue the exit
command from Profile Configuration mode for the VC class association to take
effect.
host1(config-profile)#atm pvc aal5autoconfig cbr 10000
host1(config-profile)#atm atm1483 auto-configure ppp
host1(config-profile)#atm atm1483 auto-configure ip lockout-time 3600 7200
host1(config-profile)#atm atm1483 subscriber ip user-prefix joesmith
domain myisp password-prefix abc123
host1(config-profile)#atm atm1483 description VC_atm1
host1(config-profile)#atm atm1483 advisory-rx-speed 2000
host1(config-profile)#atm class-vc premium-subscriber-class
host1(config-profile)#exit
(Optional) In the base profile, create nested profile assignments for the upper-interface
4.
encapsulation types, and include additional profile characteristics for other
encapsulation types as needed.
For example, the following commands configure nested profile assignments for the
PPP and IP upper-interface encapsulation types, and define additional attributes for
the PPPoE upper-interface encapsulation type.
host1(config-profile)#atm atm1483 profile ppp myPppProfile
host1(config-profile)#atm atm1483 profile ip myIpProfile
host1(config-profile)#pppoe duplicate-protection
host1(config-profile)#pppoe sessions 3000
Exit Profile Configuration mode.
5.
Configure the ATM and ATM AAL5 interface.
6.
host1(config)#interface atm 5/0
Configure a range of VCs on the static ATM AAL5 interface, and assign a name to this
7.
range. This operation can take several minutes to complete, depending on the number
of VCs being configured.
NOTE: For information about the maximum number of ATM 1483 bulk
configurations supported per chassis, see JunosE Release Notes, Appendix
A, System Maximums.
For example, the following command creates a VC range named myBulkConfig made
up of two VC subranges that configure a total of 5,000 virtual circuits.
Copyright © 2010, Juniper Networks, Inc.