Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 694

JunosE 11.3.x Link Layer Configuration Guide
662
host1(config-profile)#ip inactivity-timer 200
host1(config-profile)#ip auto-configure ip-subscriber include-primary
Create the base profile for the dynamic VLAN subinterface by assigning the profile a
3.
name.
host1(config)#profile vlanBaseProfile
This command accesses Profile Configuration mode, which enables you to configure
attributes in the base profile.
Define attributes for the VLAN subinterface in the base profile.
4.
a. Configure the VLAN major interface for autodetection of the PPPoE upper-interface
encapsulation type.
b. Configure the VLAN subinterface for autodetection of the IP upper-interface
encapsulation type.
c. Configure an Ethertype value for any S-VLANs configured on the VLAN.
host1(config-profile)#vlan auto-configure pppoe
host1(config-profile)#vlan auto-configure ip
host1(config-profile)#svlan ethertype 8100
(Optional) In the base profile, create nested profile assignments for the upper-interface
5.
encapsulation types.
For example, the following command configures nested profile assignments for the
IP upper-interface encapsulation types.
host1(config-profile)#vlan profile ip myIpProfile
Exit Profile Configuration mode.
6.
Configure the VLAN major interface.
7.
host1(config)#interface gigabitEthernet 5/0
host1(config-if)#encapsulation vlan
Configure a VLAN range on the major VLAN interface, and assign a name to this range.
8.
NOTE: For information about the maximum number of VLAN bulk
configurations supported per chassis, see JunosE Release Notes, Appendix
A, System Maximums.
For example, the following command creates a VLAN range named myBulkConfig
made up of two VLAN subranges.
host1(config-if)#vlan bulk-config myBulkConfig vlan-range 0 100
vlan-range 110 200
Assign the base profile configured for the VLAN subinterface to the VLAN range
9.
configured on the major VLAN interface.
host1(config-if)#profile vlan bulk-config myBulkConfig vlanBaseProfile
Configure the VLAN major interface to support autodetection of the VLAN dynamic
10.
encapsulation type.
Copyright © 2010, Juniper Networks, Inc.