Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 723

show atm vc
Copyright © 2010, Juniper Networks, Inc.
Example 5—Displays the current state of a specific ATM subinterface created on the
PVC with the specified VPI and VCI values
host1#show atm subinterface atm 0/0/0/101
Interface ATM-Prot VCD VPI VCI
----------- -------- --- --- --- ------- ----- ---- ------ ---------
ATM 0/0.101 RFC-1483 101
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Interface types in lockout
Lockout state (seconds)
------------------------------- --- --- ------- ------- ----
PPPoE
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
See show atm subinterface.
Use to display a summary of all configured ATM VCs and reserved VC ranges.
You can specify one or more of the following keywords individually or in combination:
vpi—Displays VCs on a specific VPI
category—Displays VCs that have a specific service category
status—Displays VCs with a certain status
To display only a summary of all reserved VC ranges on the router, specify the reserved
keyword with no other keywords. This includes VPI/VCI ranges reserved for use by
dynamic ATM 1483 subinterfaces.
Field descriptions
Interface—Interface identifier
VPI—Virtual path identifier
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
Circuit
Type Encap MTU
0 101 PVC AUTO
: dynamic
: PPPoE
: SNAP
: PPPoE
: none
: Min Max Current Elapsed Next
1 300
: none assigned
: none assigned
: pppoeprofile
: none assigned
5119
358672
5107
357510
0
0
3
0
Interface
Status Type
9180 up Static
0 0 1
691