Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 632

JunosE 11.3.x Link Layer Configuration Guide
show atm vc
600
Lockout state (seconds)
------------------------------- --- --- ------- ------- ----
PPPoE
Assigned profile (IP)
Assigned profile (BridgedEnet): none assigned
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
See show atm subinterface.
Use to display a summary of all configured ATM VCs and reserved VC ranges.
You can specify one or more of the following keywords individually or in combination:
vpi—Displays VCs on a specific VPI
category—Displays VCs that have a specific service category
status—Displays VCs with a certain status
To display only a summary of all reserved VC ranges on the router, specify the reserved
keyword with no other keywords. This includes VPI/VCI ranges reserved for use by
dynamic ATM 1483 subinterfaces.
Field descriptions
Interface—Interface identifier
VPI—Virtual path identifier
VCI—Virtual channel identifier
VCD—Virtual circuit descriptor
Type—Type of circuit: PVC
Encap—Encapsulation method: AUTO, AAL5, MUX, SNAP, ILMI, F4-OAM
Category—Service type configured on the VC: UBR, UBR-PCR, NRT-VBR, RT-VBR,
or CBR
Rx/Tx Peak—Peak rate, in Kbps
: Min Max Current Elapsed Next
1 300 0
: none assigned
: none assigned
: pppoeprofile
: none assigned
5119
358672
5107
357510
0
0
3
0
Copyright © 2010, Juniper Networks, Inc.
0 1