Enabling Pppoe Service Name Tables For Use With Dynamic Interfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

pppoe service-name-table

Enabling PPPoE Service Name Tables for Use with Dynamic Interfaces

Copyright © 2010, Juniper Networks, Inc.
Use to specify PPPoE as the encapsulation method for the interface.
This command creates a PPPoE major interface.
Example
host1(config-if)#pppoe
Use the no version to remove the PPPoE major interface.
See pppoe.
Use from Interface Configuration mode to assign a PPPoE service name table to a
PPPoE major interface for use by a static Fast Ethernet, Gigabit Ethernet, or 10-Gigabit
Ethernet interface.
Specify the name of the PPPoE service name table configured with the
pppoe-service-name-table command from Global Configuration mode.
Example
host1(config-if)#pppoe service-name-table myServiceTable1
Use the no version to remove the PPPoE service name table assignment.
See pppoe service-name-table.
To enable a PPPoE service name table for use with a dynamic interface, add the service
name table to a profile that is dynamically assigned to the interface.
For complete details, see "Configuring a Dynamic Interface from a Profile" on page 559 in
"Configuring Dynamic Interfaces" on page 511.
To enable a PPPoE service name table for use with a dynamic interface:
Create a profile by assigning it a name.
1.
host1(config)#profile baseProfile
Assign the PPPoE service name table to the profile as a PPPoE characteristic.
2.
host1(config-profile)#pppoe service-name-table myServiceTable1
Exit Profile Configuration mode.
3.
host1(config-profile)#exit
Configure a physical interface.
4.
On ERX7xx models, ERX14xx models, and the ERX310 router:
host1(config-if)#interface atm 3/0.1
Configure an ATM PVC by specifying the VCD, the VPI, the VCI, and the encapsulation
5.
type.
host1(config-subif)#atm pvc 10 100 22 aal5snap
Chapter 12: Configuring Point-to-Point Protocol over Ethernet
411