Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 79

cbr
ubr
vbr-nrt
Copyright © 2010, Juniper Networks, Inc.
Use to configure the CBR service category on an ATM data PVC.
You must specify a PCR, in Kbps, in the range 1–149760 (for OC3 ATM modules) or
1–599040 (for OC12 ATM modules).
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#cbr 15000
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See cbr.
Use to configure the UBR service category on an ATM data PVC.
You can optionally specify a PCR, in Kbps, in the range 0–149760 (for OC3 ATM
modules) or 0–599040 (for OC12 ATM modules).
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#ubr 5000
host1(config-subif-atm-vc)#exit
Use the no version to restore the default service category, UBR without a PCR.
See ubr.
Use to configure the variable bit rate, nonreal time (VBR-NRT) service category on an
ATM data PVC.
You must specify all of the following parameters:
PCR, in Kbps, in the range 0–149760 (for OC3 ATM modules) or 0–599040 (for
OC12 ATM modules)
SCR, in Kbps, in the range 0–149760 (for OC3 ATM modules) or 0–599040 (for
OC12 ATM modules)
Maximum burst size (MBS), in cells, in the range 0–16777215
You must issue the exit command from ATM VC Configuration mode for the
configuration to take effect.
Example
host1(config-subif-atm-vc)#vbr-nrt 50000 10000 150
host1(config-subif-atm-vc)#exit
Chapter 1: Configuring ATM
47