Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 60

JunosE 11.3.x Link Layer Configuration Guide
atm framing
atm ilmi-enable
atm ilmi-keepalive
atm lbo
28
Use to configure T3 or E3 framing on an ATM interface.
Specify one of the following framing types for a T3 (DS3) interface:
cbitadm—c-bit with ATM direct mapping
cbitplcp—c-bit with PLCP framing (default)
m23adm—M23 ATM direct mapping
m23plcp—M23 with PLCP framing
Specify one of the following framing types for an E3 interface:
g832adm—G.832 ATM direct mapping
g751adm—G.751 ATM direct mapping
g751plcp—G.751 PLCP mapping (default)
Example
host1(config-if)#atm framing g751adm
Use the no version to return framing to the default:
For a T3 interface, the default is cbitplcp
For an E3 interface, the default is g751plcp
See atm framing.
Use to enable ILMI on the interface.
Example
host1(config-if)#atm ilmi-enable
Use the no version to disable ILMI on the interface.
See atm ilmi-enable.
Use to generate ILMI keepalive messages. This value sets the time interval in seconds
between poll PDU transmissions if no sequence data PDUs are pending.
Example
host1(config-if)#atm ilmi-keepalive 5
Use the no version to disable the generation of keepalive messages.
See atm ilmi-keepalive.
Copyright © 2010, Juniper Networks, Inc.