Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 180

JunosE 11.3.x Link Layer Configuration Guide
show frame-relay subinterface
148
DLCI 16 in sub-interface mlframe-relayTEST.1, status is active
DLCI 17 in sub-interface mlframe-relayTEST.2, status is active
Example 2
host1#show frame-relay pvc interface mlframe-relay TEST
PVC information for frame relay DTE interface mlframe-relayTEST
DLCI 16 in sub-interface mlframe-relayTEST.1, status is active
Number of circuit status inactive transitions is 0
Time since creation 00:07:20, last status change 00:07:11
In pkts: 14
In bytes: 420
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 14
DLCI 17 in sub-interface mlframe-relayTEST.2, status is active
Number of circuit status inactive transitions is 0
Time since creation 00:07:20, last status change 00:07:11
In pkts: 14
In bytes: 420
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 14
See show frame-relay pvc.
Use to display the state of the subinterface.
The subinterface can be in one of the following states:
Up—Traffic can flow on the interface
Offline—Traffic cannot flow because hardware is unavailable
Down—Traffic cannot flow because of a problem in the interface at the current
protocol layer
LowerLayerDown—Traffic cannot flow because of a problem in an interface at a
lower protocol layer
AdministrativelyDown—Traffic cannot flow because of manual administrative
intervention
Use the brief keyword to display only the operational status of all configured
subinterfaces.
Use the optional delta keyword to specify that baselined statistics are to be shown.
Field descriptions
Frame relay sub-interface mlframe-relay—Name and subinterface number of the
MLFR bundle in the format bundle-name.subinterface-number
status—State of the subinterface, as follows:
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0
Copyright © 2010, Juniper Networks, Inc.