Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 111

Copyright © 2010, Juniper Networks, Inc.
Segment OAM CC verification—Whether segment CC verification is enabled or
disabled
VP State—State of the VP: up, down
VP End To End Oam State
not managed—Circuit is in normal OAM state; no OAM fault conditions
AIS—Circuit is in AIS state
RDI—Circuit is in RDI state
VP Segment Oam State
not managed—Circuit is in normal OAM state; no OAM fault conditions
AIS—Circuit is in AIS state
RDI—Circuit is in RDI state
InOamF4Cells—Number of F4 OAM cells received
InOamF4CellsDropped—Number of incoming F4 OAM cells that were dropped
InOamF4EndLoopbackCells—Total number of F4 end-to-end loopback cells received
on this interface, which is the sum of the following counts:
InOamF4EndLoopbackCommands—Number of F4 end-to-end loopback
commands received
InOamF4EndLoopbackResponses—Number of F4 end-to-end loopback responses
received
InOamF4SegLoopbackCells—Total number of F4 segment loopback cells received
on this interface, which is the sum of the following counts:
InOamF4SegLoopbackCommands—Number of F4 segment loopback commands
received
InOamF4SegLoopbackResponses—Number of F4 segment loopback responses
received
InOamF4EndAisCells—Number of F4 end-to-end AIS cells received
InOamF4SegAisCells—Number of F4 segment AIS cells received
InOamF4EndRdiCells—Number of F4 end-to-end RDI cells received
InOamF4SegRdiCells—Number of F4 segment RDI cells received
InOamF4EndCCActDeActCells—Number of F4 end-to-end activation or deactivation
CC cells received
InOamF4SegCCActDeActCells—Number of F4 segment activation or deactivation
CC cells received
Chapter 1: Configuring ATM
79