Changing Vlan Subranges - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

vlan profile
vlan service-profile

Changing VLAN Subranges

Copyright © 2010, Juniper Networks, Inc.
Original Policy
Attachment
Filter
Example
host1(config-profile)#vlan policy input VlanPolicy33 statistics enabled preserve
Use the no version to remove the association between a policy list and an interface or
a profile.
See vlan policy.
Use to add a nested profile assignment to a base profile for a dynamic VLAN
subinterface.
A nested profile assignment references another profile that configures attributes for
a dynamic upper-interface type over the VLAN subinterface.
Examples
host1(config-profile)#vlan profile pppoe vlanProfilePppoe
host1(config-profile)#vlan profile ip vlanProfileIP
Use the no version to remove the profile assignment for the upper-interface
encapsulation type.
See vlan profile.
Use to specify a service profile name for a dynamic VLAN and to enter Service Profile
Configuration mode. Service profiles contain user and password information, and are
used in route maps for subscriber management and to authenticate subscribers with
RADIUS.
You can specify a service profile name with up to 80 alphanumeric characters.
Example
host1(config)#vlan service-profile vlanClass1Service
host1(config-service-profile)#
Use the no version to delete the service profile.
See vlan service-profile.
Changing VLAN subranges within a bulk-configured VLAN range includes the following
tasks:
Adding new VLAN subranges to an existing VLAN range
Removing VLAN subranges from an existing VLAN range
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
New Policy
Attachment Comment
Filter –
673