Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 147

pos description
serial description
shutdown
snmp trap frame-relay link-status
Copyright © 2010, Juniper Networks, Inc.
Use to assign a text description or an alias to a POS HDLC interface.
You can use this command to help you identify the interface and keep track of interface
connections.
The description or alias can be a maximum of 80 characters.
Use "show interfaces pos" on page 367 to display the text description. For details, see
"Monitoring POS" on page 366 in "Configuring Packet over SONET" on page 359.
Example
host1(config-if)#pos description austin01 pos interface
Use the no version to remove the text description or alias.
See pos description.
Use to assign a text description or an alias to a serial HDLC interface.
You can use this command to help you identify the interface and keep track of interface
connections.
The description or alias can be a maximum of 80 characters.
Use the show interfaces serial command to display information about the serial
interfaces you configured. For more information about the descriptions of the fileds
displayed in the output of this command, see the show interfaces serial section in JunosE
Physical Layer Configuration Guide. For example, for a channelized T3 interface, see
the Monitoring Interfaces section in JunosE Physical Layer Configuration Guide.
Example
host1(config-if)#serial description ottawa012 hdlc channel
Use the no version to remove the text description or alias.
See serial description.
Use to disable a Frame Relay interface.
Example
host1(config-if)#shutdown
Use the no version to restart a disabled interface.
See shutdown.
Use to enable SNMP link status processing for a Frame Relay major interface or
subinterface.
To enable SNMP link status processing for a Frame Relay major interface, you must
issue the command from Interface Configuration mode.
Chapter 2: Configuring Frame Relay
115