Pppoe Over Ethernet Configurations - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
interface fastEthernet
interface gigabitEthernet
interface tenGigabitEthernet
pppoe
410

PPPoE over Ethernet Configurations

To enable a PPPoE service name table for use with a static interface in PPPoE over
Ethernet configurations:
Configure a Fast Ethernet, Gigabit Ethernet, or 10-Gigabit Ethernet physical interface.
1.
host1(config)#interface fastEthernet 4/1
Select PPPoE as the encapsulation method on the interface. This command creates
2.
the PPPoE major interface.
host1(config-if)#pppoe
Assign the PPPoE service name table to the PPPoE major interface.
3.
host1(config-if)#pppoe service-name-table myServiceTable1
Use to select a Fast Ethernet interface.
Example
host1(config)#interface fastEthernet 4/1
Use the no version to remove IP from an interface or subinterface. You must issue the
no version from the highest level down; you cannot remove an interface or subinterface
if the one above it still exists.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
For information about specifying the Gigabit Ethernet or 10-Gigabit Ethernet interface
or subinterface, see "interface gigabitEthernet" on page 400 and "interface
tenGigabitEthernet" on page 400 on "interface tenGigabitEthernet" on page 667.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1 6.0.0FRS
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface. You must issue the no version from
the highest level down; you cannot remove an interface or subinterface if the one above
it still exists.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
Copyright © 2010, Juniper Networks, Inc.