Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 365

Copyright © 2010, Juniper Networks, Inc.
Network interface administrative status—Indicates whether the interface for the
MLPPP bundle is administratively enabled (open), meaning that the no ppp
shutdown command is operational, or administratively disabled (closed), meaning
that the ppp shutdown command is operational
Link interface administrative status—Indicates whether the interface for the member
link is administratively enabled (open), meaning that the no ppp shutdown command
is operational, or administratively disabled (closed), meaning that the ppp shutdown
command is operational
Configured network protocol—Network protocol configured on the interface
Fragmentation and reassembly configuration:
Link interface fragmentation—Indicates whether MLPPP fragmentation is enabled
or disabled on the link interface
Link interface fragment size—MLPPP fragment size, in octets, currently in use on
the link interface
Link interface reassembly—Indicates whether MLPPP reassembly is enabled or
disabled on the link interface
Link interface administrative MRRU—Administrative MRRU value, in octets, currently
in use on the link interface
Baseline status—Indicates whether a statistics baseline has been set
Interface statistics:
packets—Number of packets received (in) and sent (out) on the interface
octets—Number of octets received (in) and sent (out) on the interface
errors—Number of errors received (in) and sent (out) on the interface
discards—Number of packets discarded on receipt (in) or discarded before they
were transmitted (out)
NOTE: For the LCP, IPCP, and OSINLCP negotiated options, the
command displays a value of "none" if the option was not negotiated.
LCP protocol configuration:
max-receive-unit—Controls negotiation of the local MRU option; value can be one
of the following:
use lower layer—MRU of the layer below PPP defines the MRU to be negotiated
disabled—MRU option is not to be negotiated
Chapter 9: Configuring Multilink PPP
333