Configuring Mpls Over Vlan - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
atm pvc
encapsulation bridge1483
454
Follow the steps in "Configuring VLAN Subinterfaces over Bridged Ethernet" on page 453
1.
to configure the VLAN subinterface.
Create a PPPoE major interface on the VLAN subinterface.
2.
host1(config-subif)#pppoe
Exit the subinterface context.
3.
host1(config-subif)#exit
Create a PPPoE subinterface by adding a subinterface number to the interface
4.
identification command.
host1(config)#pppoe subinterface atm 4/0.101.2.1
Specify PPP as the encapsulation method on the interface.
5.
host1(config-subif)#encapsulation ppp
Assign an IP address and mask to the interface.
6.
host1(config-subif)#ip address 10.1.1.2 255.255.255.0

Configuring MPLS over VLAN

To configure MPLS over VLAN over a bridged Ethernet interface:
Follow the steps in "Configuring VLAN Subinterfaces over Bridged Ethernet" on page 453
1.
to configure the VLAN subinterface.
Enable MPLS on the VLAN subinterface.
2.
host1(config-subif)#mpls
Use to configure a PVC on an ATM interface. Specify one of the following encapsulation
types:
aal5snap—Specifies a logical link control (LLC) encapsulated circuit;
LLC/Subnetwork Access Protocol (LLC/SNAP) header precedes the protocol
datagram.
aal5mux ip—Specifies a VC multiplexed circuit. This option is used for IP only.
Example
host1(config-subif)#atm pvc 1 5 50 aal5snap 0 0 0
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure bridged Ethernet as the encapsulation method on an ATM 1483
subinterface.
Example
host1(config-subif)#encapsulation bridge1483
Copyright © 2010, Juniper Networks, Inc.