Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 704

JunosE 11.3.x Link Layer Configuration Guide
vlan policy
672
Example
host1(config-profile)#vlan description test1
Use the no version to remove the VLAN description.
See vlan description.
Use to assign a VLAN policy list to an interface.
Use the input or output keyword to assign the policy list to the ingress or egress of the
interface.
You can enable or disable the recording of routing statistics for bytes and packets
affected by the policy.
If you enable statistics, you can enable or disable baselining of the statistics. The router
implements the baseline by reading and storing the statistics at the time the baseline
is set and then subtracting this baseline whenever baseline-relative statistics are
retrieved.
You must also enable baselining on the interface with the appropriate baseline
command.
You can use the preserve keyword to save the existing statistics when you attach a
policy to an interface that already has a policy attached. This keyword saves the
statistics for any classifier-list that is the same for both the new and old policy
attachments. Without the preserve keyword, all statistics are deleted when you attach
the new policy.
For example, when you replace a policy attachment that references the original
policy-list plOne with a new attachment referencing policy-list plTwo, the existing
statistics for the classifier group referencing clOne and the default classifier group are
saved.
Original Policy
Attachment
ip policy-list plOne
ip classifier-list clOne
Forward
ip classifier-list clTwo
Forward
ip classifier-list clThree
Forward
classifier-list *
New Policy
Attachment Comment
ip policy-list plTwo –
ip classifier-list clOne statistics from plOne are saved
Forward –
ip classifier-list clFour –
Forward –
ip classifier-list clFive –
Forward –
classifier-list * statistics from plOne are saved
Copyright © 2010, Juniper Networks, Inc.