Figure 52: Ipv4 And Ipv6 Interface Columns Over Static And Dynamic Pppoe - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Copyright © 2010, Juniper Networks, Inc.
Figure 52: IPv4 and IPv6 Interface Columns over Static and Dynamic
PPPoE
IPv4 IPv6
To configure IPv4 and IPv6 interface columns over dynamic PPPoE:
Specify the loopback mode for an interface and assign both IPv6 and IPv4 addresses
1.
to the interface.
host1(config)#interface loopback 1
host1(config-if)#ipv6 address 2000::1/64
host1(config-if)#ip address 2.2.2.1/24
Create a profile that defines attributes for the dynamic interface. You can use this
2.
profile to configure IPv4 or IPv6, or both IPv4 and IPv6 PPP interfaces.
host1(config)#profile ipv4Ipv6Profile
host1(config-profile)#ip virtual-router ppp
host1(config-profile)#ip unnumbered loopback 1
host1(config-profile)#ipv6 virtual-router ppp
host1(config-profile)#ipv6 unnumbered loopback 1
host1(config-profile)#ipv6 nd other-config-flag
host1(config-profile)#ipv6 nd ra-interval 10
host1(config-profile)#ppp authentication chap
host1(config-profile)#exit
Specify the interface.
3.
host1(config-if)#interface gigabitEthernet 4/0/6
Set the encapsulation type to PPPoE.
4.
host1(config-subif)#pppoe
Configure the interface to detect and accept dynamic PPPoE subinterfaces.
5.
host1(config-subif)#pppoe auto-configure
Assign the profile to any autoconfigured encapsulation.
6.
host1(config-if)#pppoe profile any ipv4Ipv6Profile
Chapter 17: Configuring Dynamic Interfaces
IPv6 IPv4 IPv6
Gigabit Ethernet
IPv4
535