JunosE 11.3.x Link Layer Configuration Guide
Dual-Homed
Configurations with
LAG Disabled
Ethernet Link Redundancy Behavior
212
Figure 27: GE-8 IOA Configuration Across IOAs (1:N)
Figure 28 on page 212 displays how you can configure Ethernet link redundancy with LACP
disabled locally using a dual-homed configuration. LACP is disabled because there is no
LAG at the peer.
Figure 28: Dual-Homed Configuration (1:1)
When you create a LAG bundle, you can configure LACP with the Disabled, Passive, or
Active states. For more information about these states, see "LACP" on page 198.
The following sections describe link redundancy behavior when the:
Copyright © 2010, Juniper Networks, Inc.