Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 110

JunosE 11.3.x Link Layer Configuration Guide
show atm oam
78
host1#show atm map brief
Map list my-map : PERMANENT
Map list other-map : PERMANENT
Example 3
host1#show atm map my-map
Map list my-map : PERMANENT
ip 192.168.2.10 maps to VC 10 atm 2/0
ip 192.168.2.20 maps to VC 11 atm 2/0
ip 192.168.2.30 maps to VC 12 atm 2/0
See show atm map.
Use to display F4 OAM statistics for an ATM interface.
You must specify a VPI value in addition to the required ATM interface specifier.
You can use the following keywords.
segment—Displays information about segment loopbacks
end-to-end—Displays information about end-to-end loopbacks
To see F4 OAM circuits that are open, use the show atm vc command.
Field descriptions
Sending End To End Loopback Cells—Enabled, disabled
Frequency—Frequency configured on this circuit
End To End OAM CC verification—Whether end-to-end CC verification is enabled or
disabled
OAM CC Type—Whether the circuit is a sink or a source, or both a sink and a source
OAM Current CC state
Ready—OAM CC is not enabled
Active—OAM CC cell flow is running
Activation Failed—OAM CC activation failed
Wait Activate—Waiting for interface to come up before the software sends the
activation request
Wait Activation Confirmation—Waiting for activation confirmation from the peer
Wait DeActivate—Waiting for interface to come up before the software sends the
deactivation request
Wait DeActivation Confirmation—Waiting for deactivation confirmation from the
peer
broadcast
Copyright © 2010, Juniper Networks, Inc.