Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 209

pppoe
pppoe subinterface fastEthernet
pppoe subinterface gigabitEthernet
pppoe subinterface tenGigabitEthernet
vlan description
Copyright © 2010, Juniper Networks, Inc.
Example
host1(config-if)#ip address 192.6.129.5 255.255.255.0
Use the no version to remove an IP address or disable IP processing.
See ip address.
Use to configure PPPoE as the encapsulation method on the interface.
Example
host1(config-if)#pppoe
Use the no version to disable PPPoE on the interface.
See pppoe.
Use to create a PPPoE subinterface on a Fast Ethernet interface.
Example
host1(config-if)#pppoe subinterface fastEthernet 4/1.1.1
Use the no version to remove a PPPoE subinterface on a Fast Ethernet interface.
See pppoe subinterface.
Use to create a PPPoE subinterface on a Gigabit Ethernet interface or on a 10-Gigabit
Ethernet interface.
Example 1—Creates a PPPoE subinterface on an ERX7xx model, ERX14xx model, or
the ERX310 router
host1(config-if)#pppoe subinterface gigabitEthernet 4/2.1.1
Example 2—Creates a PPPoE subinterface on the E320 router
host1(config-if)#pppoe subinterface tenGigabitEthernet 4/0/2.1.1
Use the no version to remove a PPPoE subinterface on a Gigabit Ethernet interface or
on a 10-Gigabit Ethernet interface.
See pppoe subinterface.
Use to assign an alias or description to a VLAN subinterface.
You can use a maximum of 64 characters for the description or to name the alias.
Example
host1(config-if)#vlan description randolph56a
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
177