Using Ethernet Show Commands - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Using Ethernet show Commands

show interfaces fastEthernet
Copyright © 2010, Juniper Networks, Inc.
Use the show commands described in this section to display information about your
Ethernet configuration and to monitor Ethernet interfaces.
Use to display the status of Fast Ethernet interfaces, VLAN subinterfaces, or S-VLAN
subinterfaces.
You can specify the following keywords:
delta—Specifies that baselined statistics are to be shown
brief—Displays the operational status of all configured interfaces
Field descriptions when you display the status of a Fast Ethernet VLAN or S-VLAN
subinterface
Subinterface number—Location of the subinterface that carries the VLAN or S-VLAN
traffic
Administrative status—Operational state that you configured for this interface; up
or down
VLAN ID—Domain number of the VLAN
SVLAN ID—Domain number of the stacked VLAN
Ethertype—Ethertype assignment for the S-VLAN subinterface, 0x8100, 0x88a8, or
0x9100; 0x9100 is the default
In—Analysis of inbound traffic on this interface
Bytes—Number of bytes received on the VLAN or S-VLAN subinterface
Packets—Sum of all unicast, broadcast, and multicast packets received on the
VLAN or S-VLAN subinterface
Multicast—Number of multicast packets received on the VLAN or S-VLAN
subinterface
Broadcast—Number of broadcast packets received on the VLAN or S-VLAN
subinterface
Errors—Total number of errors in all received packets; some packets might contain
more than one error
Discards—Total number of discarded incoming packets
Out—Analysis of outbound traffic on this interface
Bytes—Number of bytes sent on the VLAN or S-VLAN subinterface
Packets—Number of packets sent on the VLAN or S-VLAN subinterface
Multicast—Number of multicast packets sent on the VLAN or S-VLAN subinterface
Chapter 5: Configuring VLAN and S-VLAN Subinterfaces
189