Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 726

JunosE 11.3.x Link Layer Configuration Guide
show pppoe interface lockout-time
694
Total clients in active lockouts—Number of PPPoE clients currently undergoing
dynamic encapsulation type lockout
Total clients in lockout grace period—Number of PPPoE clients currently in a
lockout grace period; for more information about the lockout grace period, see
"Guidelines for Configuring Encapsulation Type Lockout for PPPoE sessions" on
page 523 in "Configuring Dynamic Interfaces" on page 511.
Example
host1#show pppoe interface atm 3/0.101
. . .
Lockout Configuration (seconds): Min 5, Max 60
Total clients in active lockouts: 0
Total clients in lockout grace period: 0
See show pppoe interface.
Use to display detailed information about the current encapsulation type lockout
condition for each PPPoE client associated with a dynamic PPPoE subinterface column
on a static PPPoE major interface.
Field descriptions
PPPoE interface—Specifier for the PPPoE interface
Lockout Configuration (seconds)—Encapsulation type lockout settings for the PPPoE
client associated with the dynamic PPPoE subinterface column
Min—Minimum lockout time, in seconds
Max—Maximum lockout time, in seconds
Total clients in active lockouts—Number of PPPoE clients currently undergoing
dynamic encapsulation type lockout
Total clients in lockout grace period—Number of PPPoE clients currently in a
lockout grace period; for more information about the lockout grace period, see
"Guidelines for Configuring Encapsulation Type Lockout for PPPoE sessions" on
page 523 in "Configuring Dynamic Interfaces" on page 511
Client Address—Source MAC address of the PPPoE client
NOTE: Because PPPoE sessions that contain the IWF-Session DSL Forum
VSA (26-154) use the same source MAC address of the DSLAM for all
subscriber connections, multiple entries are displayed in the Client
Address field for the same MAC address if multiple IWF sessions contain
the same MAC address.
Current—Current lockout time, in seconds; displays 0 (zero) if the PPPoE client is
not undergoing lockout
Copyright © 2010, Juniper Networks, Inc.