Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 399

baseline interface pos
show interfaces pos
Copyright © 2010, Juniper Networks, Inc.
NOTE: The E120 and E320 routers output for monitor and show commands
is identical to output from other E Series routers, except that the E120 and
E320 router output also includes information about the adapter identifier in
the interface specifier (slot/adapter/port).
Use to set a statistics baseline for POS interfaces. The router implements the baseline
by reading and storing the statistics at the time the baseline is set and then subtracting
this baseline whenever baseline-relative statistics are retrieved.
Example
host1#baseline interface pos 8/0
There is no no version.
See baseline interface.
Use to display the configuration, state, and statistics for a POS interface.
To specify a POS interface for ERX7xx models, ERX14xx models, and ERX310 router,
use the slot/port[.subinterface ] format.
slot—Number of the chassis slot
port—Port number on the I/O module
subinterface—Number of the subinterface
To specify a POS interface for E120 and E320 routers, use the slot/adapter/port format.
slot—Number of the chassis slot
adapter—Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
port—Port number on the IOA
You can include the following keywords:
delta—Specifies that baselined statistics are to be shown
brief—Displays the operational status of all configured interfaces
Field descriptions
POS interface status—State of the physical interface: up, down
Description—Text description or alias if configured for the interface
Chapter 11: Configuring Packet over SONET
367