Monitoring Atm; Setting Statistics Baselines - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

Monitoring ATM

Setting Statistics Baselines

baseline atm vp interface
baseline interface atm
Copyright © 2010, Juniper Networks, Inc.
Bridged Ethernet
IP
PPP
PPPoE
For details, see "Configuring ATM 1483 Dynamic Subinterfaces" on page 624 in "Configuring
Dynamic Interfaces Using Bulk Configuration" on page 619.
This section explains how to set a statistics baseline, display bit rate and packet rate
statistics for ATM virtual circuits (VCs), and use the show commands to view your ATM
configuration and monitor ATM VCs and VPs.
NOTE: The E120 and E320 routers output for monitor and show commands
is identical to output from other E Series routers, except that the E120 and
E320 routers output also includes information about the adapter identifier
in the interface specifier (slot/adapter/port).
You can set a statistics baseline for ATM interfaces, ATM virtual circuits, and ATM virtual
paths configured on the router.
Use to set a statistics baseline for an ATM virtual path (VP) interface.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
To set the baseline for an ATM VP, specify the VPI. The numeric range of the VPI
depends on the line module capabilities and current configuration.
To display baseline statistics, use the delta keyword with ATM show commands.
Examples
host1#baseline atm vp interface atm 12/0 0
host1#baseline atm vp interface atm 5/0/0 1
There is no no version.
See baseline atm vp interface.
Use to set a statistics baseline for ATM interfaces or a specific virtual circuit.
The router implements the baseline by reading and storing the statistics at the time
the baseline is set and then subtracting this baseline whenever baseline-relative
statistics are retrieved.
Chapter 1: Configuring ATM
67