Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 364

JunosE 11.3.x Link Layer Configuration Guide
show ppp interface mlppp
332
discards
PPP multilink member-interface serial 2/0:2/1 is up
Time since last baseline 00:10:22
Interface statistics
packets
octets
errors
discards
PPP multilink member-interface serial 2/0:3/1 is up
Time since last baseline 00:00:19
Interface statistics
packets
octets
errors
discards
PPP interface mlppp group2 is up
PPP multilink member-interface serial 2/1:1/1 is up
Time since last baseline 00:00:23
Interface statistics
packets
octets
errors
discards
PPP multilink member-interface serial 2/1:2/1 is up
Time since last baseline 00:00:25
Interface statistics
packets
octets
errors
discards
PPP multilink member-interface serial 2/1:3/1 is up
Time since last baseline 00:00:30
Interface statistics
packets
octets
errors
discards
2 mlppp interfaces found
Use to display information about MLPPP interfaces.
You can display a great variety of information with this complex command. See the
show ppp interface command in "Configuring Point-to-Point Protocol" on page 259,
for more detailed information about the display options.
Use the show ppp interface command to display information about all PPP interfaces,
including MLPPP interfaces.
Field descriptions
PPP interface mlppp—Name and administrative status (up or down) for an MLPPP
bundle
PPP multilink member-interface—Interface type, interface specifier, and
administrative status (up or down) for an MLPPP member link
0 0
in out
0 0
102 104
0 0
0 0
in out
0 0
112 126
0 0
0 0
in out
0 0
125 132
0 0
0 0
in out
0 0
135 138
0 0
0 0
in out
0 0
125 132
0 0
0 0
Copyright © 2010, Juniper Networks, Inc.