Configuring Static Atm Interfaces Within Vc Subranges - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
atm bulk-config modify
atm bulk-config shutdown

Configuring Static ATM Interfaces Within VC Subranges

650
from the specified VC range. The no version also removes any overriding profile
assignments for ATM PVCs within the deleted VC range or VC subrange.
See atm bulk-config.
Use to expand or shorten the range of the specified VC subrange. You can modify only
a single specific subrange at a time.
You can expand a subrange if none of the added circuits overlap with any other
subrange. You can shorten a subrange if none of the dropped circuits have existing
dynamic ATM 1483 subinterfaces.
Modifying a subrange so that it completely includes at least one other subrange from
within the same VC range effectively merges the subranges. Each subrange that is
merged with another frees up a subrange for subsequent configuration. The subranges
that are merged do not need to be adjacent to each other.
The router retains any overriding profiles assigned to a subrange if the assignment falls
within the modified subrange. If the assignment falls outside of the newly modified
subrange, the router drops the overriding profile assignment. If two subranges are
merged, the router retains overriding profiles that were assigned to the separate
subranges and applies the overriding profiles to the newly merged subrange.
Example
host1(config-if)#atm bulk-config test modify vc-range 2 3 210 230
There is no no version.
See atm bulk-config modify.
Use to administratively disable (shut down) a specified VC subrange or all subranges
in a VC range. The administrative state of a VC subrange is enabled by default.
Disabling the VC subrange deletes all dynamic ATM 1483 subinterfaces on the affected
subranges. You can use the show atm subinterface command or the show atm vc
command to monitor the progress of the removal of all dynamic ATM 1483 subinterfaces
for the specified subrange.
No dynamic ATM 1483 subinterfaces can subsequently be created for the subrange
until you restore the administrative state to enabled by using the no atm bulk-config
shutdown command.
Example
host1(config-if)#atm bulk-config test shutdown vc-range 2 2 201 250
Use the no version to enable the specified VC subrange or all subranges in a VC range.
See atm bulk-config shutdown.
You can do either of the following on an E Series router:
Copyright © 2010, Juniper Networks, Inc.