Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 317

Copyright © 2010, Juniper Networks, Inc.
max-negotiations—Maximum number of renegotiation attempts that the router
accepts before terminating a PPP session
ipcp prompt-option dns—Prompts the CPE (Customer Premises Equipment) to
negotiate the IPCP primary and secondary DNS options that are locally available
with the broadband remote access server (enabled or disabled)
IPV6CP protocol configuration
configured—IPv6CP is configured on this interface (true or false)
administrative-status—IPv6CP administrative status (open or closed)
ipv6-interfaceId—Address to be used for negotiation of local IPv6 address option
IPCP protocol status
operational-status—IPCP operational status (up, down, not present, or not present
no resources)
terminate-reason—Reason for termination of IPCP service
IPV6CP protocol status
operational-status—IPv6CP operational status (up, down, not present, or not
present no resources)
terminate-reason—Reason for termination of IPv6CP service
IPCP negotiated options—Shows the following negotiated addresses for the local
and remote (peer) side of the link
ip-address—IP address
ip-address-mask—IP address mask
primary-dns-address—Primary DNS address
secondary-dns-address—Secondary DNS address
primary-wins-address—Primary WINS address
secondary-wins-address—Secondary WINS address
NOTE: The command displays a value of "none" for any negotiated
option parameters if the option was not negotiated.
OSINLCP protocol configuration
configured—OSINLCP is configured on this interface (true or false)
administrative-status—OSINLCP administrative status (open or closed)
OSINLCP protocol status
Chapter 8: Configuring Point-to-Point Protocol
285