Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 668

JunosE 11.3.x Link Layer Configuration Guide
atm atm1483 description
atm atm1483 profile
atm atm1483 subscriber
636
Use the no version to terminate detection of the specified encapsulation type
See atm atm1483 auto-configure.
Use to assign a text description for ATM 1483 subinterfaces that are created with the
profile that you are configuring.
The description can be up to 255 characters.
Example
host1(config-profile)#atm atm1483 description VC_atm1
Use the no version to remove the text description.
See atm atm1483 description.
Use to add a nested profile assignment to a base profile for a dynamic ATM 1483
subinterface.
A nested profile assignment references another profile that configures attributes for
a dynamic upper-interface type over the ATM 1483 subinterface.
Example
host1(config-profile)#atm atm1483 profile pppoe atm1483ProfilePppoe
Use the no version to remove the profile assignment for the upper-interface
encapsulation type.
See atm atm1483 profile.
Use to configure a local subscriber for a dynamic upper-interface encapsulation type
configured over a dynamic ATM 1483 subinterface. A subscriber supports authentication
and configuration from the RADIUS server.
Optionally, you can include this command in the base profile for a dynamic ATM 1483
subinterface.
When you configure a subscriber, you must specify the following:
upperInterfaceType—Type of dynamic interface, bridgedEthernet or ip
userNameUsage—How the dynamic interface uses the username for authentication
purposes
user—Use the name as specified.
user-prefix—Use the name as a prefix to the interface physical location. The router
automatically postpends the physical location of the user to the username string.
The username format is userName.slot.port.vpi.vci. The resulting username string
is then used to authenticate the subscriber with the RADIUS server.
Copyright © 2010, Juniper Networks, Inc.