Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 482

Software for e series broadband services routers link layer configuration guide
Table of Contents

Advertisement

JunosE 11.3.x Link Layer Configuration Guide
ip address
ip mac-validate
450
subinterface—Number of the subinterface in the range 1–2147483647
To specify an ATM interface for E120 and E320 routers, use the
slot/adapter/port[.subinterface ] format.
slot—Number of the chassis slot
adapter—Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
port—Port number on the IOA
subinterface—Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 21 in "Configuring
ATM" on page 3.
Examples
host1(config)#interface atm 9/1.1 point-to-point
host1(config)#interface atm 5/0/1.1 point-to-point
Use the no version to remove the interface or subinterface.
See interface atm.
Use to set an IP address for the interface.
Note that you cannot add more than one IP address to bridged Ethernet interfaces.
Example
host1(config-subif)#ip address 160.1.0.1 255.255.255.0
Use the no version to remove the IP address.
See ip address.
Use to enable or disable MAC address validation on a per interface basis.
When MAC address validation is enabled, the router checks the entry in the MAC
validation table that corresponds to the IP source address of an incoming packet. The
MAC source address of the packet must match the MAC source address of the table
entry for the router to forward the packet.
Use the strict keyword to prevent transmission of IP packets that do not reside in the
validation table.
Use the loose keyword to allow IP packets to pass through even though the packets
do not have entries in the validation table. Only packets that have matching IP–MAC
pair entries in the table are validated. This is the default setting.
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents