Monitoring Pos - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
pos framing
pos scramble-atm
shutdown

Monitoring POS

366
host1(config-if)#pos description austin01 pos interface
Use the no version to remove the text description or alias.
See pos description.
Use to set the type of framing for a POS interface.
sdh—Uses SDH framing format
sonet—Uses SONET framing format (the default)
Example
host1(config-if)#pos framing sdh
Use the no version to restore the default value, sonet.
See pos framing.
Use to enable payload scrambling on a POS interface.
Payload scrambling is enabled by default. When enabled, both sides of the connection
must be using the scrambling algorithm. The router uses a 43rd-order synchronous
scrambler to scramble the output data.
Example
host1(config-if)#pos scramble-atm
Use the no version to disable scrambling on the POS interface.
See pos scramble-atm.
Use to disable a POS interface.
Example
host1(config-if)#shutdown
Use the no version to restart a disabled interface.
See shutdown.
Use the show interfaces pos command to display information about the POS interface.
You can set a statistics baseline for POS interfaces using the baseline interface pos
command.
You can use the output filtering feature of the show command to include or exclude lines
of output based on a text string you specify. See show Commands in JunosE System Basics
Configuration Guide, for details.
Copyright © 2010, Juniper Networks, Inc.