Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 105

show atm atm1483
show atm interface
show interfaces atm
Copyright © 2010, Juniper Networks, Inc.
InPackets: 0
InBytes: 0
OutPackets: 0
OutBytes: 0
InErrors: 0
OutErrors: 0
InPacketDiscards: 0
OutDiscards: 0
See show atm aal5 interface.
Use to display whether or not the router is set up to export ATM 1483 subinterface
descriptions to the line module.
Example
host1#show atm atm1483
ATM1483 IF Descriptions exported
See show atm atm1483.
Use to display configuration and state information and statistics about a specific ATM
interface, or to display a brief description of all ATM interfaces configured in the router.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310 router,
use the slot/port format.
slot—Number of the chassis slot
port—Port number on the I/O module; on the OC3-2 GE APS I/O module, you can
specify ATM interfaces only in ports 0 and 1; port 2 is reserved for a Gigabit Ethernet
interface
To specify an ATM interface for the E120 and E320 routers, use the slot/adapter/port
format.
slot—Number of the chassis slot
adapter—Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
port—Port number on the IOA
To display the status and number of configured VCs for all ATM interfaces configured
in the router, use the brief keyword.
Field descriptions
Chapter 1: Configuring ATM
73