Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 254

JunosE 11.3.x Link Layer Configuration Guide
222
Interface Specifier—Status of the hardware on this interface (up or down)
LACP active—Ethernet link participates in the protocol regardless of whether its
Partner member link is set to active or passive LACP PDU participation
LACP passive—Ethernet link transmits LACP PDUs only when it receives LACP
PDUs from its Partner link
collecting/distributing—Ethernet link is actively collecting incoming frames and
distributing outgoing frames
detached—Ethernet link is detached from the LAG bundle due to protocol changes
or system constraints
waiting—Ethernet link is waiting to attach to a LAG bundle
Example
host1#show interfaces lag members
Lag bostonBundle is Up, Administrative status is Up
Configured MinimumLinks 2
Member-interface FastEthernet0/0 is Up
(LACP active, state collecting/distributing)
Member-interface FastEthernet0/5 is Up
(LACP active, state collecting/distributing)
Lag actonBundle is Up, Administrative status is Up
Member-interface FastEthernet4/0 is Up
(LACP passive, state collecting/distributing)
Member-interface FastEthernet4/6 is Up
(LACP passive, state collecting/distributing)
2 lag interfaces found
See show interfaces lag members.
Copyright © 2010, Juniper Networks, Inc.