Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 731

Copyright © 2010, Juniper Networks, Inc.
referenced in the base profile for a dynamic ATM 1483 subinterface as nested profile
assignments
ATM Virtual Circuit Class—Name of the ATM VC class assigned to the bulk-configured
VC ranges associated with this base profile, if configured
VLAN Auto-configure—Whether autodetection of the specified upper-interface
encapsulation type (IP or PPPoE) is enabled or disabled for a dynamic VLAN
subinterface
VLAN Agent Circuit Identifier— Whether autodetection of the VLAN subinterface
uses the agent-circuit-identifier information in the option 82 field of DHCP messages
or in the DSL Forum VSA 26-1 of PPPoE PADR and PADI packets: enabled or disabled
VLAN Advisory Rx Speed—Configured advisory receive speed, in Kbps, for the dynamic
VLAN subinterface; the E Series LAC sends this value to the LNS in the RX
Connect-Speed AVP [38]
VLAN Advisory Tx Speed—Configured advisory speed, in Kbps, for the dynamic VLAN
subinterface.
VLAN Description—Text description assigned to VLAN subinterfaces that are created
with this profile
VLAN Profile—Name of the profile assigned to the specified upper-interface
encapsulation type (IP or PPPoE); these profiles are referenced in the base profile
for a dynamic VLAN subinterface as nested profile assignments
VLAN Service Profile—Service profile name for a VLAN
VLAN Svlan Ethertype—Ethertype that the packet must use this to create the dynamic
VLAN subinterface
Bridged Ethernet Mtu—MTU size configured for a dynamic bridged Ethernet interface
Bridged Ethernet Service Profile—Name of the IP service profile associated with the
interface profile for this dynamic bridged Ethernet interface
Example 1—Displays configuration information for a profile assigned to a dynamic
interface
host1#show profile name pppoeProfile
Profile
Unnumbered interface on
Router
Directed Broadcast
ICMP Redirects
Access Route Addition
Network Address Translation: Disabled
Source-Address Validation
Ignore DF Bit
Filter Option Packets
Administrative MTU
TCP MSS value
Inactivity Timer
Route Map Name
Chapter 18: Configuring Dynamic Interfaces Using Bulk Configuration
: pppoeProfile
: loopback 1
: default
: Disabled
: Disabled
: Enabled
: Disabled
: Disabled
: Disabled
: 1500
: 0
: Disabled
: Disabled
699