Troubleshooting - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual

JunosE 11.3.x Link Layer Configuration Guide
show ppp peer-ip-address-optional

Troubleshooting

log severity debug pppPacket
296
Osi
Mpls
Operational status
Interface
PPP Multilink Status
Configuration status
Link Interface
Network Interface
Ip
Ipv6
Osi
Mpls
Administrative status
Link Interface
Network Interface
Ip
Ipv6
Osi
Mpls
Operational status
Link Interface
Network Interface
Ip
Ipv6
Osi
Mpls
Operational status
Link Interface
Network Interface
See show ppp interface summary.
Use to display whether an IP address is required in a client request for an IPCP
negotiation
Field descriptions
Ppp peer-ip-address-optional—Indicates whether the peer IP address is optional in
the IPCP configuration request.
Example
host1#show ppp peer-ip-address-optional
Ppp peer ip address optional: enabled
See show ppp peer-ip-address-optional.
Use the pppPacket log to diagnose problems on your PPP interfaces. On dynamic PPP
interfaces, you can use the ppp log command within the profile, as described in
"Configuring Dynamic Interfaces" on page 511.
0 0 4000
0 0 4000
lowerDown passive tunnel
0 0 0
configured notConfigured
8000 n/a
2000 n/a
2000 0
0 2000
0 2000
0 2000
open closed
8000 0
2000 0
2000 0
2000 0
2000 0
2000 0
up down notPresent noResources
8000 0 0
2000 0 0
2000 0 0
0 0 2000
0 0 2000
0 0 2000
lowerDown passive tunnel
0 0 0
0 0 0
Copyright © 2010, Juniper Networks, Inc.
0
0
n/a
n/a
0
0
0
0