Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 123

show atm vc atm
Copyright © 2010, Juniper Networks, Inc.
Interface VPI VCI
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.8099 1 8099 8099 PVC
ATM 3/0.8100 1 8100 8100 PVC
2 circuit(s) found that match filter criteria
Example 4—Displays VCs with a VPI of 0 (zero) and a service category of CBR that
have a status of up
host1#show atm vc vpi 0 category cbr status up
Interface VPI VCI
------------ --- ---- ---- ---- ----- ---- ----- ----- ----- ---
ATM 3/0.2 0 101
1 circuit(s) found that match the filter criteria
Example 5—Displays all reserved VC ranges on the router
host1#show atm vc reserved
Reserved VCC ranges:
Start Start End End
Interface VPI VCI
--------- ----- ----- --- ---
ATM 2/0 2 100
ATM 2/0 3 300
2 reservation(s) found
See show atm vc.
Use to display information about a specific VC.
To specify the circuit to display, do one of the following:
Enter the VCD.
Use the vpi-vci keyword and enter the VPI and VCI.
Enter the description configured for the ATM 1483 subinterface (with the atm
atm1483 description command) on which the VC resides.
Field descriptions
VCD—Virtual circuit descriptor
VPI—Virtual path identifier
VCI—Virtual channel identifier
Encap—Encapsulation method
Service Type—Service type configured on the VC: UBR, UBR-PCR, NRT-VBR, RT-VBR,
CBR
Inverse ARP enable—Whether or not Inverse ARP is enabled: yes, no
Assigned VC class—Name of the VC class assigned to this VC, if configured
VCD Type Encap gory Peak
SNAP UBR
SNAP UBR
Cate Rx/Tx Rx/Tx Rx/Tx Sta
VCD Type Encap gory Peak
4375 PVC AUTO CBR 1000
VPI VCI
2 102
3 303
Chapter 1: Configuring ATM
Avg Burst tus
0 0 0 UP
0 0 0 DOWN
Avg Burst tus
0 0 UP
91