Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 129

show atm vc-class
Copyright © 2010, Juniper Networks, Inc.
OutF5EndLoopCommands:
OutFEndLoopResponses:
OutF5SegLoopCells:
OutF5SegLoopCommands:
OutF5SegLoopResponses:
OutF5EndRdiCells:
OutF5SegRdiCells:
OutF5EndCCActDeActCells:
OutF5SegCCActDeActCells:
OutF5EndCCCells:
OutF5SegCCCells:
Circuit is DOWN, time since last change: 02:25:52
See show atm vc atm.
Use to display information about the VC classes configured on the router.
To display only the names of all VC classes configured on the router, use the command
with no keywords.
To display detailed configuration information about a particular VC class, specify the
name of the VC class.
To display the settings for parameters in the VC class that are configured with default
values, use the include-defaults keyword.
Field descriptions
Encapsulation Type—Encapsulation method configured in the VC class: AUTO, AAL5,
AAL0, MUX, SNAP
Service Category—Service category configured in the VC class: UBR, UBR-PCR,
NRT-VBR, RT-VBR, CBR
Peak Cell Rate—Peak cell rate (PCR), in Kbps, configured for the service category
OAM VC Integrity—Status of F5 OAM VC integrity features on the PVC: enabled or
disabled
OAM VC Integrity loop-back timer—Number of seconds the router waits between
the transmission of loopback cells during normal operation
OAM VC Integrity Up Retry Count—Number of successive loopback cell responses
that the router receives before reporting that a PVC is up
OAM VC Integrity Down Retry Count—Number of successive loopback cell responses
that the router misses before reporting that a PVC is down
OAM VC Integrity Retry Frequency—Number of seconds that the router waits between
the transmission of loopback cells when it is verifying the state of a PVC
OAM alarm down count—Number of successive alarm cells that the router receives
before reporting that a PVC is down
0
0
0
0
0
0
0
0
0
0
0
Chapter 1: Configuring ATM
97