Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 327

Copyright © 2010, Juniper Networks, Inc.
notConfigured—Interface or protocol is not configured
Administrative status—Indicates the administrative state of the PPP interface, IPCP,
IPv6CP , OSINLCP, or MPLS
open—Interface or protocol is administratively enabled
closed—Interface or protocol is administratively disabled
Operational status (Interface)—Indicates the operational state of the PPP interface
up—Interface is operational
down—Interface is not operational because of a problem in the PPP layer
lowerDown—Interface is not operational because a lower layer in the protocol
stack is down
notPresent—Interface is not operational because the hardware is unavailable
passive—Interface is waiting for the peer to send an LCP confReq message
tunnel—Interface is being redirected through a tunnel
Operational status (Ip, Ipv6, Osi. Mpls)—Indicates the operational state of the IPCP,
IPv6CP, OSINLCP, or MPLS protocol
up—Protocol is operational
down—Protocol is not operational because of a problem in the PPP layer
notPresent—Protocol is not operational because it does not exist
noResources—Protocol is not operational because it does not exist due to a lack
of resources
PPP Multilink Status—Multilinked PPP interfaces
Example
host1#show ppp interface summary
PPP Status
Configuration status
Interface
Ip
Ipv6
Osi
Mpls
Administrative status
Interface
Ip
Ipv6
Osi
Mpls
Operational status
Interface
Ip
Ipv6
Chapter 8: Configuring Point-to-Point Protocol
configured notConfigured
4000 n/a
4000 0
0 4000
0 4000
0 4000
open closed
4000 0
4000 0
4000 0
4000 0
4000 0
up down notPresent noResources
4000 0 0
4000 0 0
0 0 4000
n/a
0
0
295