Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 751

discovery mode...................................................245
general OAM parameters configured on an
interface.............................................................250
link monitoring configured on an
interface.............................................................250
warning message
while placing local entity in remote
loopback mode...............................................242
Ethernet OAM link-fault management commands
ethernet oam lfm........................................................238
ethernet oam lfm high-threshold..........................242
ethernet oam lfm link-monitor
frame-seconds........................................................239
ethernet oam lfm link-monitor
frame-seconds-summary...................................240
ethernet oam lfm link-monitor
symbol-period...........................................................241
ethernet oam lfm mode...........................................238
ethernet oam lfm pdu-lost-threshold.................239
ethernet oam lfm pdu-transmit-interval...........239
ethernet oam lfm remote-failure..........................242
ethernet oam lfm remote-loopback start.........243
ethernet oam lfm remote-loopback stop..........243
ethernet oam lfm remote-loopback
supported...................................................................242
show ethernet oam lfm discovery........................245
show ethernet oam lfm statistics.........................248
show ethernet oam lfm status..............................250
show ethernet oam lfm summary........................253
Ethernet OAM messages See OAM messages
Ethertype value, assigning to
S-VLANs............................180, 183, 458, 542, 584, 669
Event notification OAM PDUs
description of................................................................226
generating to the remote peer................................235
generation of and sending to the remote peer
when low threshold is exceeded...................232
identification of duplicate events
using sequence number...................................233
link monitoring function and...................................232
receive link path monitoring
and transmission to the remote peer.........234
responding to received notices..............................235
supported TLVs for tracking link faults
Errored Frame Event..........................................232
Errored Frame Seconds Summary
Event....................................................................232
Errored Symbol Period Event ........................232
Copyright © 2010, Juniper Networks, Inc.
transmission of, multiple times
owing to failure in delivery...............................233
viewing............................................................................248
example....................................................................................207
examples, configuration
ATM 1483 subinterfaces, dynamic........................633
ATM VC classes.......................................................56, 64
bridged Ethernet, dynamic......................................554
bridged Ethernet, static.............................................447
Cisco HDLC....................................................................506
IPoA, dynamic..............................................................550
MLFR.................................................................................136
MLPPP, dynamic..........................................................323
MLPPP, static......................................................308, 323
Multiclass MLPPP, dynamic....................................352
Multiclass MLPPP, static...........................................353
PPPoE, dynamic..................................................525, 531
PPPoE, static......................................................384, 394
profiles for dynamic interfaces..............................588
transparent bridging..................................................485
VLAN subinterfaces, dynamic......................661, 663
exporting ATM 1483 subinterface descriptions...........43
Extensible Authentication Protocol. See EAP
external loopback...................................................................30
F
F4 OAM cells, for ATM............................................................16
configuring........................................................................32
handling of received cells............................................18
F5 OAM cells, for ATM
configuring.................................................................33, 49
disabling automatically..........................19, 25, 28, 33
handling of received cells............................................18
failover
action on exceeding high threshold
OAM link monitoring and.................................233
to secondary link of redundant port
on GE-2 and GE-HDE LMs...............................233
when high threshold is exceeded.................233
Fast Ethernet interfaces
specifying an interface...............................................183
Fast Ethernet modules
configuring PPPoE......................................................394
specifying an interface...............406, 473, 542, 666
fault management, ATM.......................................................14
Index
719