Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 182

JunosE 11.3.x Link Layer Configuration Guide
show frame-relay summary
150
In bytes: 512
In frames: 16
In errors: 0
In discards: 16
In unknown protos: 0
See show frame-relay subinterface.
Use to scan all defined Frame Relay interfaces and circuits and to report the status for
each discovered interface and circuit as follows:
Up—Traffic can flow on the interface
Down—Traffic cannot flow because of a problem in the network
Unavailable—Traffic cannot flow because hardware is unavailable
Example
host1#show frame-relay summary
2 multilink interface(s) defined, 2 up, 0 down
1 interface(s) defined, 1 up, 0 down
2 sub-interface(s) defined, 2 up, 0 down
2 circuit(s) defined, 2 up, 0 down
See show frame-relay summary.
Out bytes: 0
Out frames: 0
Out errors: 0
Out discards: 0
Copyright © 2010, Juniper Networks, Inc.