Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 450

JunosE 11.3.x Link Layer Configuration Guide
radius override nas-port-id remote-circuit-id
radius remote-circuit-id-delimiter
radius remote-circuit-id-format
418
Use the no version to restore the default Calling-Station-Id value, which is the telephone
number from which the call originated.
See radius override calling-station-id remote-circuit-id.
Use to configure RADIUS to override the standard use of the NAS-Port-Id [87] RADIUS
attribute and instead use the PPPoE remote circuit ID transmitted from a DSLAM.
Example
host1(config)#radius override nas-port-id remote-circuit-id
Use the no version to restore the default NAS-Port-Id value, which is the physical
interface of the network access server (NAS) that is authenticating the user.
See radius override nas-port-id remote-circuit-id.
Use to configure the delimiter character that the router uses to set off multiple
components in the format of the PPPoE remote circuit ID value captured from a DSLAM.
Example
host1(config)#radius remote-circuit-id-delimiter !
Use the no version to restore the default delimiter character, #.
See radius remote-circuit-id-delimiter.
Use to configure the format of the PPPoE remote circuit ID value captured from a
DSLAM.
By default, the router formats the PPPoE remote circuit ID to include only the
agent-circuit-id suboption (suboption 1) of the tags supplied by the PPPoE intermediate
agent.
You can use this command to configure one of the following nondefault formats for
the PPPoE remote circuit ID value:
To include the agent-circuit-id suboption, use the agent-circuit-id keyword.
To include the agent-remote-id suboption (suboption 2) of the tags supplied by the
PPPoE intermediate agent, use the agent-remote-id keyword.
To include the NAS-Identifier [32] RADIUS attribute, use the nas-identifier keyword.
If you include the nas-identifier keyword, you must also include either or both of the
agent-circuit-id and agent-remote-id keywords.
To append the agent-circuit-ID value to an interface specifier that is consistent with
the recommended format in DSL Forum Technical Report (TR)-101—Migration to
Ethernet-Based DSL Aggregation (April 2006)the , use the dsl-forum-1 keyword.
For details about how the router implements this format, see "Format for dsl-forum-1
Keyword" on page 377.
Copyright © 2010, Juniper Networks, Inc.