Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - LINK LAYER CONFIGURATION GUIDE 2010-10-13 Configuration Manual page 672

JunosE 11.3.x Link Layer Configuration Guide
auto-configure atm1483
interface atm
640
You can optionally include the oam keyword and a number of seconds in the range
1–600 to enable generation of OAM F5 loopback cells on this circuit. This option enables
VC integrity features that affect the operational state of the ATM PVC.
Example
host1(config-profile)#atm pvc aal5autoconfig cbr 10000 oam 120
Use the no version to restore the default service type, UBR, on the VC range.
See atm pvc.
Use to configure the static ATM AAL5 interface to support autodetection of an ATM
1483 dynamic interface type.
You must issue this command to enable creation of a dynamic ATM 1483 subinterface.
Example
host1(config-if)#auto-configure atm1483
Use the no version to terminate autodetection of the ATM 1483 encapsulation type.
See auto-configure atm1483.
Use to select an ATM interface or ATM 1483 subinterface.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310 router,
use the slot/port.[subinterface ] format.
slot—Number of the chassis slot
port—Port number on the I/O module
subinterface—Number of the subinterface in the range 1–2147483647
To specify an ATM interface for E120 and E320 routers, use the
slot/adapter/port[.subinterface ] format.
slot—Number of the chassis slot
adapter—Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router) or the upper
IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or the lower
IOA bay (E320 router).
port—Port number on the IOA
subinterface—Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 21 in "Configuring
ATM" on page 3.
Examples
Copyright © 2010, Juniper Networks, Inc.